When the Log Box v3/USB v3 is connected to the PC with the USB Cable.
The Green LED stays solid when idle and connected to the PC.
The Red LED indicates ECU Read/Write is happening..
When the Log Box v3/USB v3 is connected to the PC with the USB Cable and you are viewing Live Engine Data.
The Green and Orange LED's indicate engine data is being requested, and received.
The Red LED indicates that Engine Data is being sent to the PC.
When the Log Box v3 is connected to the bike only.
The Log Box v3 will start data logging. (depending on the Device Configuration: Log Start Configuration settings)
The Green and Orange LED's indicate engine data is being requested, and received.
The Red LED indicates data is being saved to the SD Card.
The USB v3 will do nothing.
Log Box/USB faults.
If all 3 LED's are flashing together at the same time, this means the device is in Firmware Mode. Either the switch is in the Left position, or the software has put it into Firmware Mode. (The software can put the device in firmware mode automatically when it sees a new update is available for it, normally no user interaction is required for the auto-updates)
There is normally no reason to move the switch unless you are performing a manual firmware update/reinstallation.
If all 3 LED's are flashing in sequence, one after the other, this means the device can not detect the SD Card. The SD Card must be fitted, for normal use of the device. Try formatting the Card (format as FAT32/default settings)
These Support Center articles may also be of interest to you: