Wolich Racing communication interfaces are used to read/write to ECUs. Older generations of these interfaces (eg. v1 and v2 Log Box and USB interfaces) used a USB-COM port adapter which was configured in the software. This article applies specifically to these older interfaces and is not applicable to v3 interfaces..
If the COM Port is still not showing in the 'Settings' form within the Woolich Racing Tuned software you may need to re-install the USB COM Port driver.
-
Log into Windows as an Administrator
-
Open 'Device Manager' and locate the 'Ports (COM and LPT)' section
-
Plug the USB Interface or Log Box into the computer's USB port, make sure the mode switch is in Flashing Mode (red led on).
-
You should see the USB Serial Port appear in the list in 'Device Manager' under the 'Ports (COM and LPT)' section.
-
Right mouse click the 'USB Serial Port' and choose 'Uninstall' from the menu.
-
Ensure the 'Delete the driver software for this device' checkbox is checked.
-
Click the 'OK' button to finish uninstalling the driver.
-
Unplug the USB Interface or Log Box from the Computer
-
Reboot the computer
-
Log into Windows as an Administrator
-
Install and configure the COM Port drivers following the instructions from the previous post
Note: the USB Interface or Log Box needs to be plugged into the USB port on the computer and the mode switch needs to be in Flashing mode (red led
on) for the COM Port to appear in the Woolich Racing Tuned software settings form and in Windows Device Manager.
These Support Center articles may also be of interest to you: