The Woolich Racing Tuned (WRT) software and associated hardware allows you to read/write to most motorcycle ECUs and thereby to modify the bike's tuning. The communication with the ECU uses the Woolich Racing Tuned software running on a PC or laptop as well as a communication interface such as a Log Box or USB interface. There have been several interfaces developed over the last years and at the time of writing the current version is v3.
This article shows how to use the legacy v1 and v2 interfaces to read an ECU so is NOT applicable to v3 interfaces.
If you want to read an ECU with a v3 interface please see this article instead:
Step-by-step guide to reading and writing to your ECU with a v3 interface
The following steps should be followed when writing to an ECU
- Install Harness according to the Installation Instructions.
- Connect Interface to Harness
- Connect the Interface to the computer with the supplied USB cable. Please note that we recommend using a high-speed USB port.
- Ensure bike is in Neutral with Kill Switch in Run Position
- Turn Ignition off or 12V power supply off (when using bench harnesses)
- Put Interface switch into Center Position
- Open Woolich Racing Tuned software
- Turn on Ignition or 12V Power Supply (when using bench harness)
- The ECU should now be in flashing mode.
- Start writing to the ECU.
These Support Center articles may also be of interest to you: